|
|
 |
 |
| Bandwidth |
DC to 70MHz (-3dB) |
| Attenuation |
1:100/1000 |
| Accuracy |
+/- 2% |
| Rise Time |
<5ns |
| Input
Impedance |
50Mohm//7pF
each side to ground |
| Input Voltage |
| ¡@-Differential Range |
+/-700V(DC + Peak AC) or 500Vrms @ 1/100
+/-7000V(DC + Peak AC) or 5000Vrms @ 1/1000 |
| ¡@- Common Mode Range |
+/-7000V(DC + Peak
AC) or 5000Vrms @ 1/100 & 1/1000 |
¡@-
Absolute Max. Voltage
(Differential or Common Mode) |
+/-7000V(DC
+ Peak AC) or 5000Vrms @ 1/100 & 1/1000 |
| Output Voltage |
| ¡@-
Swing |
+/-7V(into 50kohm load) |
| ¡@-Offset (typical) |
<+/-5mV |
| ¡@-Noise
(typical) |
0.9mVrms |
| ¡@-Source Impedance (typical) |
50 ohm (for using 1M£[ input system oscilloscope) |
CMRR (typical)
| -80dB@50Hz;
-60dB@20kHz |
|
Ambient Operating Temperature|
-10 to 40 degree centigrade |
|
Ambient Storage Temperature| -30 to 70 degree centigrade |
|
Ambient Operating Humidity
| 25 to 85% RH |
|
Ambient Storage Humidity
| 25 to 85% RH |
|
| Power Requirements* |
| ¡@-Standard |
4xAA cells
| ¡@-Options |
Power leads, Mains adaptor*(6VDC/200mA or regulated 9VDC/120mA), USB power cord |
| Length
of BNC Cable |
90cm |
| Length of Input Leads |
60cm |
| Weight |
500gms |
| Dimension (LxWxH) |
202mm x 83mm x
38mm |
| |
|
* a. The supplied voltage must be less than 12V and greater than 4.4V, otherwise the probe could be damaged or can¡¦t operated properly.
b. Polarity is ¡§+¡¨ inside and ¡§-¡¨ outside. For wrong polarity, built-in circuit protects the probe, no danger or damage will occur.
c. When the voltage of the cells become too low, the power indicator on the panel will flicker.
|
| |
|
Features:
¡EUp to +/- 7000V(DC+Peak AC) Differential
¡EBandwidth up to 70MHz
¡ESafety Certified
¡EOverrange Indicator
Applications:
¡EHigh Voltage Floating Measurement
¡EVoltage Surge Measurement
¡EPower Electronics System Design
|
|
Sapphire Instruments Co.,Ltd.¡@¡@¡@¡@¡@