|
 |
 |
 |
| Bandwidth |
DC to 800MHz(-3dB) |
| Attenuation |
1/10 |
| Accuracy |
+/-2% |
| Rise Time |
0.4375ns |
| Input Impedance |
100kohm//2pF each
side to ground |
| Input Voltage* |
| ˇ@- Differential Range |
+/-15V (DC+peakAC) |
| ˇ@- Common Mode Range |
+/-30V (DC+peakAC) |
ˇ@- Absolute Max. Voltage
(either input to ground) |
+/-40V (DC+peakAC) |
| Output Voltage
|
| ˇ@- Swing |
+/-1.5V (into 50 ohm load) |
| ˇ@-Offset (typical) |
<+/-5mV |
| ˇ@-Noise (typical) |
0.3mVrms |
| ˇ@-Source
Impedance (typical) |
50ohm (for using 50 ohm input system
oscilloscope) |
| CMRR (typical) |
60dB@60Hz, 15dB@500MHz
|
| Power Requirements |
Regulated 15VDC/100mA
mains adaptor |
| Ambient Operating Temperature |
-10 to 40 degree centigrade |
| Ambient Storage Temperature |
-30 to 70 degree centigrade |
| Ambient Operating Humidity |
25 to 85% RH |
| Ambient Storage Humidity |
25 to 85% RH |
| Length of BNC Lead |
120cm |
| Length of Input Leads |
50cm |
| Weight |
130gms |
| Dimensions(LxWxH) |
111mm x 22mm x
14mm |
| |
|
ˇ@* Voltage limit is the lesser of the DC+Peak AC and RMS values.
ˇ@** a. The supplied voltage must be less than 16V and greater than 3.3V, otherwise the probe could be damaged or canˇ¦t be operated properly.
ˇ@ b. For wrong polarity of power sources, a built-in circuit will protect the probe and no danger or damage will occur.
ˇ@ c. When the voltage of the cells become too low, the power indicator on the panel will change its color and then distinguish.
|
| |
|
Features:/strong>
ˇEBandwidth up to 800MHz
ˇELow Input Capacitance
ˇEComplete accessories allows easy probing of SMDs Applications:
ˇEWireless and Data Communication
ˇEDisk Drive Design
ˇECommunication Pulse Shape Compliance
ˇELocation of Ground Bounce
|
Sapphire Instruments Co.,Ltd.ˇ@ˇ@