|
 |
 |
 |
| Bandwidth |
DC to 200MHz(-3dB) |
| Attenuation |
1/10 |
| Accuracy |
+/-1% |
| Rise Time |
1.75ns |
| Input Impedance |
500kohm//7pF each
side to ground |
| Input Voltage* |
| ¡@- Differential Range |
+/-20V (DC+peakAC) |
| ¡@- Common Mode Range |
+/-60V (DC+peakAC) |
¡@- Absolute Max. Voltage
(either input to ground) |
+/-60V (DC+peakAC) |
| Output Voltage
|
| ¡@- Swing |
+/-2V (into 50 ohm load) |
| ¡@-Offset (typical) |
<+/-2mV |
| ¡@-Noise (typical) |
0.3mVrms |
| ¡@-Source
Impedance (typical) |
50ohm (for using 50 ohm input system
oscilloscope) |
| CMRR (typical) |
-800dB@100Hz, -50dB@10MHz
|
Power Requirements
(Four options of power sources) |
Mains adaptor (6VDC/90mA or 9VDC/70mA) or
Regulated 15VDC/100mA
mains adaptor or
Power leads or USB power cord |
|
Optional Extension Plugs for Mains Adaptor |
| ¡@-Input |
One jack of 1A current
rating |
| ¡@-Output |
Three plugs of 1A current
rating |
| Ambient Operating Temperature |
-10 to 40 degree centigrade |
| Ambient Storage Temperature |
-30 to 70 degree centigrade |
| Ambient Operating Humidity |
25 to 85% RH |
| Ambient Storage Humidity |
25 to 85% RH |
| Length of BNC Lead |
125cm |
| Length of Input Leads |
50cm |
| Weight |
300gms |
| Dimensions(LxWxH) |
111mm x 22mm x
14mm |
| |
|
¡@* Voltage limit is the lesser of the DC+Peak AC and RMS values..
¡@** a. The supplied voltage must be less than 16V and greater than 3.3V, otherwise the probe could be damaged or can¡¦t be operated properly.
¡@ b. For wrong polarity of power sources, a built-in circuit will protect the probe and no danger or damage will occur.
¡@ c. When the voltage of the cells become too low, the power indicator on the panel will change its color and then distinguish.
|
| |
|
Features:
¡EBandwidth up to 200MHz
¡E0.1mV Sensitivity
Applications:
¡ETelecom Measurement
¡ExDSL Applications
¡EHigh Speed Power Measurement
¡EDifferential Line Transmitter and Receiver Design
|
Sapphire Instruments Co.,Ltd.¡@¡@¡@¡@¡@