| Bandwidth | DC to 100MHz (-3dB) | ||
| Attenuation Ratio | 1:100/1000 | ||
| Accuracy | +/- 2% | ||
| Rise Time | 3.5ns | ||
| Input Impedance | 4Mohm//7pF each side to ground | ||
| Input Voltage | |||
| -Category | CAT III | ||
| -Differential Range |
+/- 140V(DC+Peak AC) or
140Vrms @ 1/100 +/-1400V(DC+Peak AC) or 1000Vrms @1/1000 |
||
| -Common Mode Range | +/-1400V(DC+Peak AC) or 1000Vrms @1/100 & 1/1000 | ||
|
-Absolute Max. Voltage (Differential or Common Mode) |
+/-1400V(DC+Peak AC) or 1000Vrms @1/100 & 1/1000 | ||
| Output Voltage | |||
| - Swing | +/-7V (into 50kohm load) | ||
| -Offset (typical) | <+/-5mV | ||
| -Noise (typical) | 0.9mVrms | ||
| -Source Impedance (typical) | 50 ohm (for using 1Mohm input system oscilloscope) | ||
| CMRR (typical) | -80dB @60Hz, -50dB @1MHz | ||
| Ambient Operating Temperature | -10 to 40 degree centigrade | ||
| Ambient Storage Temperature | -30 to 70 degree centingrade | ||
| Ambient Operating Humidity | 25 to 85% RH | ||
| Ambient Storage Humidity | 25 to 85% RH | ||
| Power Requirements* | |||
| -Standard | 4xAA cells | ||
| -Options | Power leads, Mains adaptor* (6VDC/200mA or regulated 9VDC/120mA), USB power cord | ||
| length of Input Leads | 30cm | ||
| Length of BNC Cable | 95cm | ||
| Weight | 500gms | ||
| Dimension(LxWxH) | 207mm x 83mm x 38mm | ||
|
* a. The supplied voltage must be less than 12V and greater than 4.4V, otherwise the probe could be damaged or can¡¦t be operated properly. b. polarity is "+" inside and "¡V" outside. For wrong polarity, built-in circuit protects the probe, no danger or damage will occur. c. When the voltage of the cells become too low, the power indicator on the panel will flicker. |
|||
Features:
Applications:
|
|||
 Sapphire Instruments Co.,Ltd. 
16F, 866-9, Jung-Jeng Rd., Jung-Ho City, 235 Taipei County, Taiwan, ROC TEL: 886-2-22250572 (Rep.) FAX: 886-2-22253412 Email : tina@sapphire.com.tw Web Site : www.sapphire.com.tw |
|||