Main area

	Bandwidth	DC to 25MHz (-3dB)
	Attenuation Ratio	1:20/200
	Accuracy	+/- 2%
	Rise Time	14ns
	Input Impedance	4Mohm//5.5pF each side to ground
	Input Voltage
	б@-Differential Range	+/- 140V(DC+Peak AC) or 140Vrms @ 1/20 +/-1400V(DC+Peak AC) or 1000Vrms @1/200
	б@-Common Mode Range	+/-1400V(DC+Peak AC) or 1000Vrms @1/20 & 1/200
	б@-Absolute Max. Voltage (Differential or Common Mode)	+/-1400V(DC+Peak AC) or 1000Vrms CAT III @1/20 & 1/200
	Output Voltage
	б@- Swing	+/-7V (into 50kohm load)
	б@-Offset (typical)	<+/-5mV
	б@-Noise (typical)	0.7mVrms
	б@-Source Impedance (typical)	50 ohm (for using 1Mohm input system oscilloscope)
	CMRR (typical)	-80dB @50Hz, -60dB @20kHz
	Ambient Operating Temperature	-10 to 40 degree centigrade
	Ambient Storage Temperature	-30 to 70 degree centingrade
	Ambient Operating Humidity	25 to 85% RH
	Ambient Storage Humidity	25 to 85% RH
	Power Requirements*
	б@-Standard	4xAA cells
	б@-Options	Power leads, Mains adaptor* (6VDC/60mA or regulated 9VDC/40mA), USB power cord
	Length of BNC Cable	95cm
	length of Input Leads	45cm
	Weight	400gms (probe and PVC jacket)
	Dimension(LxWxH)	170mm x 63mm x 21mm

б@* a. The supplied voltage must be less than 12V and greater than 4.4V, otherwise the probe could be damaged or canбжt be operated properly.
б@ b. polarity is бз+би inside and бзбVби outside. For wrong polarity, built-in circuit protects the probe, no danger or damage will occur.
б@ c. When the voltage of the cells become too low, the power indicator on the panel will flicker.

Features:
бEUp to +/- 1400V(DC+Peak AC) Differential and common Mode
бESafety Certified
бEEconomical Cost

Applications:
бESwitching Power Supply Design
бEMotor Drive Design
бEElectronic Ballast Design
бECRT Display Design

  Sapphire Instruments Co.,Ltd.

16F, 866-9, Jung-Jeng Rd., Jung-Ho City, 235 Taipei County, Taiwan, ROC

TEL: 886-2-22250572 (Rep.)     FAX: 886-2-22253412

Email : tina@sapphire.com.tw     Web Site : www.sapphire.com.tw