| Bandwidth | DC to 200MHz (-3dB) | ||
| Attenuation Ratio | 1/10 | ||
| Accuracy | +/- 1% | ||
| Rise Time | 1.75ns | ||
| Input Impedance | 500kohm//7pF each side to ground | ||
| Input Voltage* | |||
| -Category | CAT I | ||
| -Differential Range | +/- 20V(DC+Peak AC) | ||
| -Common Mode Range | +/-60V(DC+Peak AC) | ||
|
-Absolute Max. Voltage (Differential or Common Mode) |
+/-60V(DC+Peak AC) | ||
| Output | |||
| - Swing (into 50ohm load) | +/-2V | ||
| -Offset (typical) | <+/-2mV | ||
| -Noise (typical) | 0.3mVrms | ||
| -Source Impedance (typical) | 50 ohm (for using 50ohm input system oscilloscope) | ||
| CMRR (typical) | -80dB @100Hz, -50dB @10MHz | ||
|
Power Requirements (Three options of power sources) |
Mains adaptor (6VDC/90mA or 9VDC/70mA) or Removable battery pack (4xAA cells) or Power leads | ||
| Optional Extension Plugs for Mains Adaptor | |||
| -Input | One jack of 1A current rating | ||
| -Output | Three plugs of 1A current rating | ||
| Ambient Operating Temperature | -10 to 40 degree centigrade | ||
| Ambient Storage Temperature | -30 to 70 degree centingrade | ||
| Ambient Operating Humidity | 25 to 85% RH | ||
| Ambient Storage Humidity | 25 to 85% RH | ||
| Length of BNC Cable | 125cm | ||
| length of Input Leads | 50cm | ||
| Weight | 300gms | ||
| Dimension(LxWxH) | 111mm x 22mm x 14mm | ||
|
* Voltage limit is the lesser of the DC+Peak AC and RMS values. ** a. The supplied voltage must be less than 16V and greater than 3.3V, otherwise the probe could be damaged or can¡¦t be operated properly. b.For wrong polarity of power sources, a built-in circuit will protect the probe and no danger or damage will occur. c. When the voltage of the cells become too low, the power indicator on the panel will change its color and then distinguish. |
|||
Features:
Applications:
|
|||
 Sapphire Instruments Co.,Ltd. 
16F, 866-9, Jung-Jeng Rd., Jung-Ho City, 235 Taipei County, Taiwan, ROC TEL: 886-2-22250572 (Rep.) FAX: 886-2-22253412 Email : tina@sapphire.com.tw Web Site : www.sapphire.com.tw |
|||